WangSpec Front Brake Duct Shields (Pair) - Toyota JZA80 Supra / Z30 Soarer (SC300)

❄️ Keep Your Brakes Cool. Keep Laps Consistent.

WangSpec’s 3D-printed stainless brake duct shields direct cooling air straight into the rotor hub of the JZA80 Supra & Z30 Soarer / SC300.

• Cooler brakes = longer life for seals, fluid, and pads.
• No hub removal required → install without pressing out bearings.
• OEM-like fit thanks to precision 3D scans of factory knuckles.
• Extended Component Life: By reducing heat transfer into the knuckle, these shields help protect wheel bearings, seals, and grease from thermal breakdown — extending service life under repeated high-heat cycles.

⚡ Why These Shields Beat OEM

• 316L Stainless Steel → superior heat & corrosion resistance (no rust like OEM stamped steel).
• SLM Metal 3D Printing → single-piece construction, integrated spacers, no weld seams.
• Optimized geometry → smooth organic transitions only possible with additive manufacturing.
• 50 mm (2”) duct inlets → standard motorsport hose size.

📦 What’s Included

• LH + RH brake duct shields (pair)
• Stainless M6x25mm hex flange bolts (for install)
• PDF install guide

Hoses & scoops sold separately.

✅ Key Features

• Directs airflow into rotor hub
• No hub removal for install
• Made-to-order in stainless or titanium
• Integrated spacer design standard

🔒 Made-to-Order Production

Each pair is made-to-order using SLM 3D printing.
⏳ Typical lead time: 3–4 weeks.
Orders fulfilled in sequence 

👉 Reserve your set now.
Stainless Steel
Titanium

✅ Fitment Guarantee

If these don’t fit your OEM Supra/Soarer knuckles, return them. No hassle.

🔒 Warranty & Support

• Lifetime warranty against manufacturing defects (fitment or structural failure under normal use).
• Normal SLM build texture or minor post-processing marks are cosmetic and not covered.
• Questions: Contact Us

📐 Notes & Limitations

• Designed for OEM Toyota knuckles only → not guaranteed with angle kits, bump steer correction, or modified uprights.
• Cleared for factory 12.6" rotors. Minimum rotor hat ID = 190 mm.
• Not compatible with tie rod relocation kits (hose entry interference). a

📄 Download the Installation & Product Info Guide

⚠️ Off-Road and Racing Use Only:
Unless explicitly stated otherwise, this product is intended for off-road or closed-course competition use only. It is not certified for public road use and may not comply with local emissions or safety regulations. The end user assumes all responsibility for legal compliance in their jurisdiction.